Rosen DVD Entertainment System Manuel du propriétaire télécharger pdf (Page 25)

AV7500 Installation Guide AP1024 Rev A

Page 3

5 Mounting the AV7500 electronics into the headrest bucket

You will need to mount the AV7500 electronics unit into the headrest bucket. The following steps will guide

you through this process.

CAUTION!

Do NOT press directly on the surface of the LCD. This will cause permanent damage

to the LCD which will not be covered by warranty.

Always REMOVE ANY SLACK in the cables during assembly. Failure to follow this step may

cause damage to the cables.

Step 1: Place the lower edge of the AV7500 unit into the

headrest bucket first. Be sure that the lower edge of the

AV7500 unit does NOT go below the top surface of the

headrest bucket (see figure 3). Use caution so the material

on the bucket is not damaged.

Step 2: Pull any additional slack created in the cables

through the headrest posts.

Step 3: Align electronics on electronics mounting bracket.

Push firmly, the side latch will “click” to lock monitor in

place. Remove excess cable slack! Use caution NOT to

press on the LCD surface as this can cause permanent

damage to the LCD. (see figure 4)

IMPORTANT!

Do not force electronics into the bracket, the components are designed to easily align

when properly installed.

BE 100% CERTAIN TO REMOVE ALL SLACK in the cables during assembly of the

units. Failure to follow this step may damage the unit, internal cables or prevent the

unit from properly closing. If you feel resistance when closing the unit, please confirm

that all cable slack has been removed.

Fig. 3

Fig. 4

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31

Pas de commentaire

Rosen DVD Entertainment System Manuel du propriétaire Page 25