Rosen Mazda 3 Guide d'installation télécharger pdf (Page 4)

Installation Guide Mazda 3

Installation Guide DP-MZ1014 Rev A

Page 4

LOCATING REMOTE COMPONENTS

You will need to mount the GPS and Optional Satellite Radio Antennas on the exterior of the vehicle.

And mount the iPod Interface Connector in the vehicle. The following steps will help guide you

through this process.

STEP

Use Caution around SRS Components

It is the installer’s responsibility to ensure that the safety

equipment in the vehicle is NOT adversely affected by installation

of this system. Ensure that the routing of the harnesses do NOT

obstruct airbags, SRS or other safety devices.

Mount the GPS and Sat Radio antenna in a

location on the exterior of the Vehicle

Route the GPS harness away from other power harnesses in the

vehicle.

This will help to ensure optimum performance of the GPS system.

“OPTIONAL”

Install the iPod interface connector in a

location accessible to the end-user

Locate the iPod interface module in an area which can be

serviced in the future.

The iPod cable is intended to be a serviceable item, which plugs

into the iPod/Sat radio Interface Module.

Install The Rosen Navigation System

You will need to prepare the Rosen Navigation System for installation in the vehicle

STEP

Remove the DVD Transport Screws

There are 2 x Phillips Transport Screws which protect the DVD

Mechanism during transportation.

Transport Screws must be removed prior to installation.

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Rosen Mazda 3 Guide d'installation Page 4